Launch ATLps weight

1 TAMAÑO OF THE AREA OF LAUNCHES

The launch area of weight consists of the circle launch, a container and fall of the device. The circle will have an inner diameter of 2,135 m (± 5mm). The sector of fall of weight will have an angle of 34,92º and a length related to the level and athletic category of competing launchers. See the drawings

And the following table:

LAUNCH AREA OF WEIGHT
DIMENSIONS COMPETITIONS
NATIONAL AND
INTERNATIONAL
REGIONAL AND
LOWER
LONGITUDE SECTOR MÍNIMA (m) 25 20

The fall can accurately be drawn by establishing a 12 m distance between two points located on each line of the sector to 20 m from the center of the circle.

For each metro progress from the center of the circle the distance between sector lines will increase in 0.60 m.

2 OUTER BANDS AND SECURITY

To facilitate the development and vision of the competition by athletes and spectators, as well as security measure bands will be reserved minimum free spaces around the circle and around the perimeter of the sector of falls. Free space around the circle of launches and its external platform, must be limited by a circle concentric with him and 6.635 m of diameter.

The angle of the sector of crashes (34,92º) must be complemented in the sides by two sectors circular tenth, in which space should not be allowed access by unauthorized persons during the launch by security measure.

3 HEIGHT FREE OF OBSTACLES

The height between the pavement and the nearest obstacle (power lines in outdoor facilities; underside of roof, luminaire, through air conditioning, in covered facilities) both on the area as on the outer bands should be totally free and have a minimum of 7 m.

SOLAR ORIENTACIÓN 4

The central axis of the circle of launches and falls can be oriented in the geographic address for as long as this is not covered by the environment O-SO (area) N-NE (circle).

TYPE OF FLOORING 5

The circle of launches will be a pavement different characteristics in crashes and external gangs. The pavement of the circle must have solved the drainage superficial and deep waters, as well as being rough and not slippery, not abrasive, consistent and equipped with safety underfoot, all this in order to be an area suitable for the evolution of the launchers. The circle is typically formed by a concrete floor 25 N / mm2 of resistance to compression, armed with metal mesh and finishing ruleteado to have sufficient adhesion and getting a flat horizontal surface. If used asphalt or other material, have a similar characteristics. At the edge of the circle will be three sewer (for example: tubes of brass or PVC 20 mm diameter) evenly distributed, at the level of the surface of the circle and so that reaches the infrastructure permeable or are connected to the network of drain. The center of the circle of launches from which you measure distances will be signposted and preferably through a brass pipe 4 mm in diameter interior placed at surface level of the circle.

The pavement of crashes sector and its outer bands admitted a maximum outstanding in the direction of launch of 1 per 1000, to enable the evacuation of superficial waters. The pavement must have solved the drainage deep waters, as well as being a deformable enough material to the impact left clear mark, without causing irreparable damage and without having to sign the footsteps of judges and competitors. The pavement will pitch, preferably, for national and international competitions, and for other competitions in its default, clay or ashes.

6 ILUMINACIÓN

Artificial lighting is uniform and so that does not cause glare of athletes, judges nor spectators. Mark the standard UNE-EN 12193 “ Illumination of sports facilities ” and will have the following minimum levels of illumination:

LEVELS OF ILUMINACIÓN MÍNIMOS
ATHLETICS abroad (all activities)
COMPETICIÓN LEVEL Horizontal illuminance
And med (lux) Uniformity
And min / Emed
International and national competitions 500 0.7
Local and regional competitions, training high level 200 0.5
Training, school sport and recreation 100 0.5

For TV broadcasts of color and recording movies requires a vertical illuminance levels of at least 1,000 lux and 1,400 lux in international competitions, however this value can increase with distance from the camera to the object. For more information regarding vertical illuminance, uniformity, color temperature and Performance index of color must consult the mentioned law.

7 ROUTE OF THE AREA

The layout of the area of launches will agree with drawings

Launch areas of weight should be located in full independence and different location of the remaining athletic fields, with the exception of the possible and partial overlap in their sectors of fall with launches of disk, hammer and javelin.

Launch areas of weight will consist of a single circle and sector or by several circles and sectors to allow a sports practiced simultaneously.

The width of the lines (whitewashed graffiti or) or existing tapes is 5 cm, remain outside areas that delimit. The marking of lines on the platform of the circle must be perfectly acceded, be permanent as well as enrasar with the surface. The marking of lines or tapes on the sector of crashes, must be perfectly acceded and be mobile, unless it is independent character to others.

The full route, you can specify the following details:

7a) median line of the circle: Is the line that restricts the later half of the circle. Is perpendicular to the central axis of the sector declines, coinciding its posterior edge with the center of the circle. line runs and pintará, at least 75 cm outside the circle and from both ends, with a width of 5 cm and white.

7b) lateral Lines: the drops sector will be limited laterally by the sidelines of the sector. The sidelines of drop sector can be accurately establishing a 12 m distance between two points located on each line of the sector to 20 m from the center of the circle. For each metro progress from the center of the circle the distance between the sector lines will increase in 0.60 m

The sector aperture (straight separation between the edges of the “ interior lateral lines ”) for a certain distance, must be obtained by multiplying the distance by the factor 0.60.

7c) indicator Lines of distance: Is optional marking over the area of crashes of certain lines that indicate entire distances launch in 2 2 metres. These lines will be plotted circumference arches with centre in the circle and with 8-10-12-14 radios.... m to mark these distances. These arches facilitate visually appraising distances by launchers and spectators.

8 THE CIRCLE AND ITS CONTAINER

The weight must jumping off a circle of the dimensions indicated in point 1.

A cap or container is placed firmly fixed to the floor, in the central part of the semicircunferencia limiting the front half of the circle next to falls.

The circumference limit shall consist of flat sheet iron, steel or another suitable material thickness of at least 6 mm and its top will be at the same level of the ground outside. The device is typically formed by a series of pieces curves, to set them in solidarity to the base platform of the circle, so that their faces interiors constitute a perfect circumference. The tube or device is set so that its top face is at the same level as the ground outside and 20 mm (± 6 mm) higher than the inner surface of the circle. This device or tube will be ready to resist all weather conditions must be painted
white on their faces views.

It will allow the existence and use of portable character circles so long as it meets the above features.

The container will be of wood or any other material fit so be prepared to resist all weather conditions. Will Be built so that it can be fixed firmly to the ground, resisting the thrust of the foot of the launcher, at the end of his effort. Should be painted white. The inside the container is placed on and in the extension of the inside of the device or tube; to adapt the circle, the container must have a length on the inside face (measure on the arc) 122 cm (± 1 cm) as well as a width of 11.2 cm to 30 cm and a height from level interior of the circle of 10 cm (± 0.2 cm), will have a rope 115 cm (± 1 cm) in length for an arc equal to the circle.

9 BANNERS OR INDICATORS

9th) Banners in the sector: The sector banners are those that complete the extremes of the “ lateral lines of the sector. ” Will Be protected metal corrosion, no metal oxidable or other appropriate material. The banderola will be rectangular and of about 400 x 200 mm. The mast will take 8 mm diameter, rising on the level of the pavement a minimum of 600 mm.

9b) Indicators away.: Can be indicators of distance outside the sector in the intersection of “ sector lateral lines ” and “ indicator lines of distances. ” Unregulated characteristics.

9c) Banners indicators: Depending on the category of the competition, it should be noted with a banner or special disk distance from the current record, either global, continental, national...

10 WEIGHT

The weight (IED) will take spherical shape. It Will Be stocky, iron, brass or other material hard over the last, or a wrapper of any of these metals, fill out of lead or other material. Its surface will be smooth. Must comply with the characteristics that are in the following table:

THE WEIGHT
Features CATEGORÍAS MEN
Senior
Promise
Junior * Youth Cadet Child Fingerling Baby
Mass (1) (g) 7.265
;
6,005
6,025
5,005
5,025
4,005
4,019
3,005
3,025
2,005
2,025
Minimum mass (2) (g) 7,260 6 5,000 4,000 3,000 2
Min. diameter (mm) 110 105 100 95 90 90
Max. diameter (mm) 130 125 120 110 105 105
(1) Mass Oscillation allowed in the manufacture to provide the weight for competition
(2) Minimum mass to the approval of rows

* Authorized to launch with senior devices

THE WEIGHT
Features WOMEN CATEGORÍAS
Senior
Promise
Junior * Youth Cadet Child Fingerling Baby
Mass (1) (g) 4,005
4,019
3,005
3,025
2005
2005
Minimum mass (2) (g) 4,000 3,000 2
Min. diameter (mm) 95 90 90
Max. diameter (mm) 110 105 105
(1) Mass Oscillation allowed in the manufacture to provide the weight for competition
(2) Minimum mass to the approval of rows

* Authorized to launch with senior devices

The devices used in international competitions, must meet the specifications of the international association of athletics Federations (IAAF) and can only be used artifacts they possess an existing Certificate IAAF.

In world championships, Olympics and Drinks in the world, all artifacts will be provided by the organizing committee and athletes are not allowed to use other devices.

In the remaining athletes competitions may use their own always devices that are controlled and approved by the committee organized and available to all athletes.

11 FURNITURE

Is placed outside the platform of the circle, furniture to that judges to develop their work.